After following some very sound of advice from you TR guru's i bought a Mocal oil cooler stat from rimmers and cut the oil cooler pipes and placed it in the cooler circuit as directed on the installation leaflet. wrong ways to fit them according to the instructions. was the stat plumbed in wrong? richard. Quote; Link to post Share on other Flex-a-lite's standard oil cooler fittings are 1/2" NPT. Plain-end hoses require barbed adapter fittings; hoses with threaded INSTALLING AS AN ENGINE OIL COOLER INSTALLATION INSTRUCTIONS for 4590_ and 4595_ Oil coolers Model 4595_ QTY GatorClip mounting clamp (9) 1/4-20 x 2.5" bolt (3) 1/4-20 Nylok nut (3) I have fitted a Mocal oil cooler to my 67 4a ,it has the sandwich fitting between filter head and filter. After fitting oil pressure has gone from 70/75 cold to 85/90 cold and 60 hot to 65 hot. I am worried that because the oil gauge is before the sandwich is there a restriction caused giving a h A company formed off the back of Rob Potter's experience and expertise gained in a radiator repair company in the early 1960s, Mocal have grown to become one of the biggest names in cooling parts and components with a particularly popular range of oil coolers. Having developed a range of coolers that were sold as factory or OE parts on MG and The fitting instructions for the thermostat are below: 1. Select suitable place for fitting the thermostat away from moving parts and at a place where hoses run parallel. 2. With ignition turned off (high tension lead disconnected), turn engine over on starter and note which pipe carries the oil supply from the engine. in mounting the oil cooler in various locations and positions. Forspecial applications we can provide bulk lengths of hose (stainless braid AQP or R6 textile) and fittings (aircraft type) for customer D.I.Y. assembly. BATinc. 7630 Matoaka Road. Sarasota, FL 34243 phone (941) 355-0005 fax (941) 355-4683 MOCAL USA MOCAL USA Back to HOME Racetech oil coolers by Mocal with Raceparts. Our maximum working pressure on the standard range of coolers is 10 bar (150psi) and tested to 11.5 bar (170psi). Push-Fit Hose and Fittings Catch Tanks Engine Oils AN Fittings on Oil Cooler . Step 6 - Install the BSP fittings into the Mocal sandwich plate. Use the supplied washers and follow the manufacturer's instructions. Step 7 - Install the sandwich plate to the block. Drain the oil, remove the oil filter, clean the sealing surface well. Put a coating of oil on the sandwich plate rubber fitting. These coolers come ready to be fitted to a hose end and should not require any further adaptors. Two sizes are commonly available, either a 115mm or 235mm width matrix. The working pressure of the Racetech oil cooler is 10 BAR (150psi). The recommended temperature range is -40⁰C to +150⁰C. The specification of these coolers are: Number of Rows. Cooler Cooler +44 (0) 208 568 1172 Thames House, Ashford Road, Ashford, TW15 1XB info@thinkauto.com thinkauto.com FITTING INSTRUCTIONS OT/4 Thermostatic Oil Control A positive control for engine oil temperature for use in conjunction with all types of oil cooler including vehicle manufacturers original equipment. 12g: Locate the Z1 SS - 8 Non-Turbo Oil Cooler Line Set included in this kit. 12h: Beginning at the oil cooler, begin routing the oil cooler lines thru the chassis. The shorter of the two lines will attach to the Passenger side fitting on the Oil Cooler Core while