Generally, in most buildings, the standpipe system can be designed as a Class I system due to the provision of Exception I to Section 905.3.1 of the IBC for buildings protected throughout by automatic sprinkler systems. NFPA 14 permits Class I standpipe systems to be manual wet systems for buildings not classified as a high-rise above 75 ft. Standpipe PDF Guide. 21 page guide for standpipes. View and Download Standpipe Guide. for the Installation of Standpipe and Hose Systems. Visit NFPA 14 Site to Read More Visit NFPA 14 Site to Buy. Information. Wet-automatic. Water supply valve automatically opens or system is Manual-wet. Water in the system; Water supply must be In a manual standpipe system the local fire department apparatus is used to provide the water supply to attain the required 100 psi at the remote standpipe outlet. Even in a system with an automatic supply, hydraulic calculations are required for the FDC as if it were a manual standpipe. • Manual--Wet. This standpipe type is not connected to a permanent water supply. The fire department connects to a hydrant and supplies the system. The standpipe is filled with "priming water" to reduce the time it takes to get water to the hose station outlets. to approve the installation of a manual standpipe system where the responding fire department is capable of providing the required hose flow at the highest standpipe outlet. The location of the standpipe is based on the standpipe system classifica-tion: Class I standpipes shall be provided in every required stairway for each floor above or Manual Dry Standpipe system are exclusively for fire department use and require a fire department pumper to supply the need pressure and water supply through a fire department connection. In North America, a standpipe is a type of rigid water piping which is built into multi-story buildings in a vertical position, or into bridges in a horizontal position, to which fire hoses can be connected, allowing manual application of water to the fire. Every standpipe system (with the exception of the manual dry variety) requires that a water flow alarm device is installed in a portion of the piping between the water supply and the initial hose connection. This alarm sounds to provide notice that the system is engaged during a fire. 4.19 Manual Wet Standpipe Sizing (2019) Reference: 2016 NFPA 14, Sections 7.8.1 and 7.10 . Purpose: All manual wet standpipes shall be hydraulically sized to provide the minimum flow and pressure required per NFPA 14. I. The standpipe shall be sized to provide the required flow and pressure (500 GPM for the most Standpipe systems are fixed piping systems with associated equipment that transports water from a reliable water supply to designated areas of buildings. Such systems are typically provided in tall and large-area buildings. These systems can significantly improve the efficiency of manual fire-fighting operations by eliminating the need for long and cumbersome hose lays from fire apparatus to a STANDPIPE-PAC™ consists of expertly chosen and assembled components, including: An air compressor specifically sized for your standpipe's pressurization requirements. Compressor controls to ensure proper and cost effective compressor operation. Built-in air drying to avoid water in your standpipe - after all, the idea is to keep the dry Score: 4.1/5 (58 votes) . Manual wet standpipe systems are similar to automatic wet systems in that water sits in the pipes at all times. To achieve enough pressure, the fire department must